Difference between revisions of "3D Printed Parts"

Revision as of 10:43, 30 May 2020

Print all parts with the following print settings:

PLA
0.4mm nozzle
No supports
0.2mm layer height
6 perimeter layers (This is especially critical for parts that have heat-set inserts)
20% infill * printable in the provided orientations
outer perimeter layer first
2-3mm brim recommended, but not required

However, exceptions do exist! Please check the breakdown below for exceptions.

Note that parts that peel off the bed with a small curl cannot be used. They must stick to the bed such that they remain flat.

Other materials, such as PETG, may also work. We welcome feedback on various materials if others find them successful.

@@ Line 44: / Line 44: @@
 * 1x [https://github.com/machineagency/jubilee/blob/master/frame/fabrication_exports/3d_printed_parts/frame/front_right_bed_coupling_lift.STL front_right_bed_coupling_lift.STL]
 * 1x [https://github.com/machineagency/jubilee/blob/master/frame/fabrication_exports/3d_printed_parts/frame/back_bed_coupling_lift.STL back_bed_coupling_lift.STL]
-* 1x [https://github.com/machineagency/jubilee/blob/master/frame/fabrication_exports/3d_printed_parts/frame/left_motor_plate.STL left_motor_plate.STL]
-** print from PETG
-** Note: an [https://www.mandalaroseworks.com/jubilee/stepperMounts aluminum version] of this part is now available.
-* 1x [https://github.com/machineagency/jubilee/blob/master/frame/fabrication_exports/3d_printed_parts/frame/right_motor_plate.STL right_motor_plate.STL]
-** print from PETG
-** Note: an [https://www.mandalaroseworks.com/jubilee/stepperMounts aluminum version] of this part is now available.
 * 1x [https://github.com/machineagency/jubilee/blob/master/frame/fabrication_exports/3d_printed_parts/frame/left_motor_corner_bracket_spacer.STL left_motor_corner_plate_spacer.STL]
 * 1x [https://github.com/machineagency/jubilee/blob/master/frame/fabrication_exports/3d_printed_parts/frame/right_motor_corner_bracket_spacer.STL right_motor_corner_plate_spacer.STL]