3D Printed Parts

From Jubilee
Jump to navigation Jump to search

Default Print Settings

Print all parts with the following print settings:

  • PLA (Two PETG exceptions exist! See below)
  • 0.4mm nozzle
  • No supports
  • 0.2mm layer height
  • 6 perimeter layers (This is especially critical for parts that have heat-set inserts)
  • 20% infill * printable in the provided orientations
  • outer perimeter layer first
  • 2-3mm brim recommended, but not required

However, exceptions do exist! Please check the breakdown below for exceptions.

Note that parts that peel off the bed with a small curl cannot be used. They must stick to the bed such that they remain flat.

Other materials, such as PETG, may also work. We welcome feedback on various materials if others find them successful.

Frame Printed Parts and Quantities

Toolchanger Parts and Quantities

Extruder-Specific Frame Parts

Assembly Fixtures Parts and Quantities