Add your Slicer
Many Slicer packages can be made compatible with Jubilee, provided that they respect the following two nuances.
- GCode Style * Jubilee uses “Marlin-flavored” GCode accepting absolute travel command moves but relative extruder command moves.
- Tool Change Convention
- Since the firmware keeps track of changing tools, invoking a tool change from the Slicer is just a matter of sending over the “Tx” command (i.e: T0, T1, etc) of the desired tool to switch to. GCode after a “Tx” command will be executed with the printer holding “Tool-x.”
- Restrict the build volume to 300mm x 300mm x 300mm
- Firmware type should be set to either Marlin or RepRap
Setting up your Slicer:
Add this snippet as your “start” GCode
M190 S[first_layer_bed_temperature] ; Wait for the bed to reach printing temperature G91 ; relative moves G1 Z1 F900 ; raise tool 1mm G90 ; absolute moves T-1 ; Make sure nothing is parked on the carriage G0 X150 Y150 F10000; Move to the center of the print area M558 F500 ; Set the probing speed G30 ; Do a single probe M558 F50 ; Set a slower probing speed G30 ; Do a second probe
Some Slicers do not prefix the rest of the GCode with the tool number. Since Jubilee starts with tools deselected by default, you will need to get your slicer to specify the tool it wants to use before actually extruding. To do this in Slic3r and PrusaSlic3r, the command is:
Other packages may or may not need something similar. Check your exported GCode file before printing!
Add this snippet as your “end” GCode.
T-1 ; desect current tool G0 Z305 ; move bed all the way to the bottom M104 S0 T0; turn off extruder 0 M104 S0 T1; turn off extruder 1 M140 S0 ; turn off bed G0 X0 Y0 F30000; return home M84 S600; disable motors after ten mins of inactivity
Tool Change GCode
Some slicers leave this section completely up to the user. You will need to ensure that the “T” command corresponding to the next extruder to use is placed before the set of extrusion commands for that particular tool. In Slic3r and PrusaSlic3r, this is the following command:
In other slicers, you may not need to add anything. Check your slicer output with a text editor before running your GCode!