Difference between revisions of "Bondtech Direct Drive Extruder"
Jump to navigation
Jump to search
Poofjunior (talk | contribs) (Created page with "This is the default extruder. It’s compatible with both an E3D V6 and an E3D Volcano nozzle. This extruder will work with the fabrications specs below with nozzle temps up t...") |
Poofjunior (talk | contribs) |
||
| Line 1: | Line 1: | ||
| + | [[File:Bondtech direct drive extruder.png|thumb]] | ||
This is the default extruder. It’s compatible with both an E3D V6 and an E3D Volcano nozzle. This extruder will work with the fabrications specs below with nozzle temps up to 250C and a bed plate temperature up to 80C. | This is the default extruder. It’s compatible with both an E3D V6 and an E3D Volcano nozzle. This extruder will work with the fabrications specs below with nozzle temps up to 250C and a bed plate temperature up to 80C. | ||
Revision as of 00:48, 11 May 2020
This is the default extruder. It’s compatible with both an E3D V6 and an E3D Volcano nozzle. This extruder will work with the fabrications specs below with nozzle temps up to 250C and a bed plate temperature up to 80C.
Note: motor heatsinks are not optional! If you operate the motors without heatsinks, the tool plates will warp from the heat. Exposure to radiated heat from the nozzle and the bed is fine up to 80C
Parts to Buy
For a set of two extruders, all parts to buy are called out in this spreadsheet tab.
Assembly Tools
3D Printed Parts and Settings
Common Settings
- PLA
- 0.4mm nozzle
- No supports
- 0.2mm layer height
- 6 perimters
- 20% infill (any pattern)
Parts and Special Settings
- Blower Fan Shroud
- Print with support material
- Tool Plate
- 100% infill (yeup, solid)
- Extruder Holder
- Groovemount Clip
- Left Parking Wing
- Right Parking Wing
- Wedge Plate
- 0.1mm layer height. This is critical
- Ooze Wiper
- Tool Cable Management Bracket
- Parking Post Base 47mm
- Tool Holder 47mm