Machined Parts
The following parts must be machined:
- the twist lock shaft
- the build plate
- the crossbar
Optionally you can machine the these parts for increased rigidity, heat dispersion, and general coolness factor : (STEP files and PDF links below)
However, some vendors can either machine these parts for you, or they now carry them as a stock part. Note that these parts are already included in the Jubilee Shopping List.
The Twist Lock
The twist lock shaft was modified to be compatible with the specifications presented in the E3D ToolChanger. However, as it has slightly different features because the underlying system operates differently, it is a distinct part.
Purchasing Options
- Joshua Vasquez via Tindie
- SeeMeCNC
- Luke’s Laboratory
Machining Options
- Dimensioned Drawing
- STEP file
The Bed Plate
The bed plate is made from 6.35mm thick MIC6 Aluminum, colloquially known as cast tool plate. This tool plate arrives surfaced, meaning that it is extremely flat to a high degree of specification. MIC6 Aluminum also thermally expands evenly when heated, which means the plate will not warp when heated with a silicone mat as is common for 3D printers.
If you machine the bed plate yourself, you can purchase a 14in. x 14in. x 1/4in. sheet of cast tool plate from Midwest Steel Supply or OnlineMetals. Please refer to the dimensioned drawing for hole features.
Purchase Options
The bed plate can also purchased from one of various vendors either with or without magnets. Magnetic surfaces enable the use of a magnetic spring steel build plate. Non-magnetic surfaces can be made printable with surfaces like glass.
The purchase options are as follows.
- MIC6 Aluminum Bed Plate with Magnets
- MIC6 Aluminum Plate without Magnets
Machining Options
- Dimensioned Drawing
- STEP file
The Crossbar
The crossbar carries the X-axis rail and the tool carriage. The current revision is a pocketed aluminum crossbar, enabling the machine to carry heavier tools and operate at higher temperatures without warping.
- ~160 grams
- Top Speed: 15000 - 20000 mm/min.
Purchasing options
- US Vendor: Mandala Rose Works
- EU Stockist: hightemp3d.com
Machining Options
- Dimensioned Drawing
- STEP file
Note: the Deprecated Carbon Fiber Crossbar
Light and stiff. This option was part of the original design, made by requesting a custom DXF from CNCMadness and installing four press-fit composite inserts. Assembly Instructions remain on the wiki.
- ~140 grams + 20 grams with inserts
- Top Speed: 15000 - 20000 mm/min.
Machined Upgrades
Some parts aren't required to be machined, but serve as an upgrade path if replaced with machined parts.
Motor Plates And Corner Plates
If you machine the motor plates and corner brackets yourself, you can purchase some .25" Aluminum plate from OnlineMetals Or you can purchase them from Mandala Rose works.