Specifying Your Build Options
Jump to navigation Jump to search
The V2 Shopping List assumes configuring Jubilee for 3D printing with two tool heads, but some alternate parts might be better for different use cases. All options are listed below, and options labeled as default are present in this shopping list.
- Default: Duet2 + Duex5
- Duet3 + Raspberry Pi + 2 Duet Expander Boards
- this is not yet officially supported with a config file, but the back panel has a hole pattern to accomodate these boards.
- Default: Plain MIC6 Aluminum Plate + 305x305 High Temperature Magnetic Sheet
- Upgrade: MIC6 Aluminum Plate with embedded magnets
- This bed plate heats up in a speedy 1-2 minutes and should be fine operating at temperatures no more than 150C.
- **Alternate:** MIC6 Aluminum Plate BYOM (Bring your own magnets) Style
- This plate has pockets for magnets, but you will need to supply your own magnets
305x305mm Magnetic Build Plate Options
- Budget: Fablam Flexplate by SeeMeCNC
- Save $30US. These may become the default in a future revision.
- Default: BuildTak Flexplate
- Default: Aluminum Crossbar
- Deprecated: 6mm Carbon Fiber Crossbar
XY Motor Options
- Default: Stepper Online Motors
- Part Number: 17HM19-2004S1 Spec Sheet
- Upgrade: LDO 0.9 Nema 17 MAX Power Motors sold by Filastruder
- Part Number: LDO-42STH60-2004MAC(RC) Spec Sheet
- The Default Extruder can accommodate an E3D V6 (default) or Volcano nozzle without adjusting the heights of other components.
- Metal Corner Plates - Made by Mandala Rose Works (also sold by hightemp3d in the EU)
- Metal Stepper Plates - Made by Mandala Rose Works (also sold by hightemp3d in the EU)
- These stepper plates are stiffer and have the added benefit of acting like heatsinks for the XY motors.
- [Hemera Extruder Tool]
- [9mm Belt Upgrade]
- [E3D Tool Plate Style Bondtech Extruder] comparable to the default extruder