Difference between revisions of "Purchased Parts"
m (Add SMC Compression Flexure) |
m (SeeMeCNC Link) |
||
| Line 23: | Line 23: | ||
** [https://www.mandalaroseworks.com/jubilee/stepperMounts Aluminum stepper mounts] | ** [https://www.mandalaroseworks.com/jubilee/stepperMounts Aluminum stepper mounts] | ||
** [https://www.mandalaroseworks.com/jubilee/frontCorners Aluminum corner brackets] | ** [https://www.mandalaroseworks.com/jubilee/frontCorners Aluminum corner brackets] | ||
| − | * [https://www.seemecnc.com/ | + | * [https://www.seemecnc.com/collections/jubilee/ SeeMeCNC] |
** [https://www.seemecnc.com/products/jubilee-back-side-panel?_pos=2&_sid=51372dc9d&_ss=r V1 back panel] | ** [https://www.seemecnc.com/products/jubilee-back-side-panel?_pos=2&_sid=51372dc9d&_ss=r V1 back panel] | ||
** [https://www.seemecnc.com/products/jubilee-ethernet-side-panel?_pos=1&_sid=51372dc9d&_ss=r V1 Ethernet side panel] | ** [https://www.seemecnc.com/products/jubilee-ethernet-side-panel?_pos=1&_sid=51372dc9d&_ss=r V1 Ethernet side panel] | ||
Revision as of 14:29, 10 May 2020
Purchased parts for Jubilee are broken down into multiple shopping lists
- (Current) Jubilee V2.0.2
- V2 Frame Shopping List (~$1485)
- V2 2x Direct Drive Extruder Shopping List (~$200 per tool)
- (Community Contributed) Jubilee V2.0.2 UK/EU BOM by HaythamB
- V2.0.2 Frame Shopping List last updated Apr 12, 2020
- (Deprecated) Jubilee V1
- V1 Frame Shopping List (~$1550)
- V1 2x Direct-Drive Extruder Shopping List (~$200 per tool)
Warnings About Cutting Your Own Extrusions
The shopping list specifies that the 2020 extrusions be cut-to-length by the vendor Misumi. This choice is intentional because Misumi can cut parts better (typically within +/- 0.1mm) than most Jubilee builders can without specialized tools. Later sections of the instructions also assume that extrusions of the same length are actually the same length; otherwise the squaring techniques in the instructions will not work. Long-story short: don’t cut the extrusions yourself unless you have a highly repeatable cutting setup.
Jubilee Component Vendors
Some small-scale manufacturers and part vendors are either reselling Jubilee’s hard-to-make parts, consolidating parts into kits, or selling modified parts from the stock model. These vendors are:
- 713Maker
- Mandala Rose Works
- SeeMeCNC
- Double Jump Electric (Joshua Vasquez)
- Luke’s Laboratory
- High Temp 3D
Alternates
Depending on region-specific constraints some parts may be harder to purchase. We welcome suggestions and will list them here.