Purchased Parts

Purchased parts for Jubilee are broken down into multiple shopping lists * (Current) Jubilee V2.0.2 * V2 Frame Shopping List (~$1485) * V2 2x Direct Drive Extruder Shopping List (~$200 per tool) * (Community Contributed) Jubilee V2.0.2 UK/EU BOM by HaythamB * V2.0.2 Frame Shopping List last updated Apr 12, 2020 * (Deprecated) Jubilee V1 * V1 Frame Shopping List (~$1550) * V1 2x Direct-Drive Extruder Shopping List (~$200 per tool)

Warnings About Cutting Your Own Extrusions

The shopping list specifies that the 2020 extrusions be cut-to-length by the vendor Misumi. This choice is intentional because Misumi can cut parts better (typically within +/- 0.1mm) than most Jubilee builders can without specialized tools. Later sections of the instructions also assume that extrusions of the same length are actually the same length; otherwise the squaring techniques in the instructions will not work. Long-story short: don’t cut the extrusions yourself unless you have a highly repeatable cutting setup.

Jubilee Component Vendors

Some small-scale manufacturers and part vendors are either reselling Jubilee’s hard-to-make parts, consolidating parts into kits, or selling modified parts from the stock model. These vendors are:

• 713Maker
  • magnetic bed plates
  • non-magnetic bed plates
• SeeMeCNC
  • V1 Back Panel
  • V1 Ethernet Side Panel
  • V1 120V Side Panel
  • V2 Back Panel
  • V2 Ethernet Side Panel
  • V2 120V Side Panel
  • magnetic bed plates
  • non-magnetic bed plates
  • Assembled Twist Locks
  • pre-laser-cut Delrin components
• Double Jump Electric (Joshua Vasquez)
  • Assembled Twist Locks
• Luke’s Laboratory
  • cut-to-length spring guide
  • mechanical “vitamin kits” for just the toolchanger (V2)
  • Assembled Twist Locks, and pre-laser-cut Delrin components for the toolchanger only.
• High Temp 3D
  • Spring Guide cut to length
  • Complete 2020 Misumi Extrusion Kits
  • Mandala Rose Works Jubilee crossbar
  • Jubilee twist lock
  • M3 Heat-set inserts
  • Mandala Rose Works * Jubilee crossbar

Alternates

Depending on region-specific constraints some parts may be harder to purchase. We welcome suggestions and will list them here.