Purchased Parts

Purchased parts for Jubilee are broken down into multiple shopping lists

• (Current) Jubilee V2.1.2
  • V2 Frame Shopping List (~$1350)
  • V2 2x Direct Drive Extruder Shopping List (~$200 per tool)
• (Community Contributed) Jubilee V2.0.2 UK/EU BOM by HaythamB
  • V2.0.2 Frame Shopping List last updated Apr 12, 2020
• (Deprecated) Jubilee V1
  • V1 Frame Shopping List (~$1550)
  • V1 2x Direct-Drive Extruder Shopping List (~$200 per tool)

Warnings About Cutting Your Own Extrusions

The shopping list specifies that the 2020 extrusions be cut-to-length by the vendor Misumi. This choice is intentional because Misumi can cut parts better (typically within +/- 0.1mm) than most Jubilee builders can without specialized tools. Later sections of the instructions also assume that extrusions of the same length are actually the same length; otherwise the squaring techniques in the instructions will not work. Long-story short: don’t cut the extrusions yourself unless you have a highly repeatable cutting setup.

Jubilee Component Vendors

Some small-scale manufacturers and part vendors are either reselling Jubilee’s hard-to-make parts, consolidating parts into kits, or selling modified parts from the stock model. These vendors are:

• 713Maker
  • Magnetic bed plates
  • Non-magnetic bed plates
• Mandala Rose Works
  • Jubilee crossbar
  • Aluminum stepper mounts
  • Aluminum corner brackets
• SeeMeCNC
  • V1 back panel
  • V1 Ethernet side panel
  • V1 120V side panel
  • V2 back panel
  • V2 Ethernet side panel
  • V2 120V side panel
  • Magnetic bed plates
  • Non-magnetic bed plates
  • Assembled twist locks
  • Pre-laser-cut Delrin components
  • Compression Flexure
• Double Jump Electric (Joshua Vasquez)
  • Twist Locks
• Filastruder
  • Twist Locks
  • T8x2 and T8x4 Leadscrews, 375mm long
  • Tool Wedge Plates
  • M3 and M4 Heat Set Inserts
  • REL Extension Spring
  • REL Hub
  • Spring Guide
  • Thrust Bearings
  • Jubilee LDO Motor Kit
  • Gates Pulley/Idler/Belt Motion Set
  • Tool Balls
  • Plum Couplers
  • Shoulder Screws
  • Jubilee Back Panel
  • Coming Soon: Jubilee Fastener Kit
• Luke’s Laboratory
  • Cut-to-length spring guide
  • Mechanical “vitamin kits” for just the toolchanger (V2)
  • Assembled twist locks
  • Pre-laser-cut Delrin components for the toolchanger only.
• High Temp 3D
  • Spring guide cut to length
  • Complete 2020 Misumi extrusion kits
  • Mandala Rose Works Jubilee crossbar
  • Mandala Rose Works aluminum corner brackets
  • Mandala Rose Works aluminum stepper mounts
  • Jubilee twist lock
  • M3 Heat-Set Inserts
  • Aluminum Hub, 6 mm ID
  • REL Replacement Extension Spring
• Powge
  • Jubilee Pulleys/Idlers/Belts Motion Kit
  • T8x2 Leadscrews, 375mm Long (leadscrew nuts are not threaded)
• Printed Solid
  • Jubilee LDO Motor Kit

Alternates

Depending on region-specific constraints some parts may be harder to purchase. We welcome suggestions and will list them here.