Printing with Cura

Please keep in mind this is a work in progress. I have my Jubilee printing how I feel is relatively well with cura but at the same time my config is a mismash of me probably making changes that aren't needed so I would use this is a vary rough guidelines Special thanks to everyone who helped me get it this far. Hopefully we can form this into a more cohesive guide. -Tsunaminaut

Cura Machine Settings for Jubilee (3 Tools)

This is my start gcode section in machine settings in Cura

G28 ;homes the printers x y z and u

T0 P0 ;Activates tool with P0 so so its standby and set temperature can be set without picking it up

T1 P0 ;Activates tool with P0 so so its standby and set temperature can be set without picking it up

T2 P0 ;Activates tool with P0 so so its standby and set temperature can be set without picking it up

G10 P0 S205 R160 ;Me setting temps as I use the printer settings addon to prevent cura from sending temp info due to how weird my duet reacted to it

G10 P1 S185 R160 ;Me setting temps as I use the printer settings addon to prevent cura from sending temp info due to how weird my duet reacted to it

G10 P2 S205 R160 ;Me setting temps as I use the printer settings addon to prevent cura from sending temp info due to how weird my duet reacted to it

T-1 P0 ;Makes all tool inactive but will maintain standby temp

G32 ;3 point bed level

M190 S65 ;Setting my bed temp

G29 S1 ;Loading my mesh?

Here is my end gcode section

M104 S0 ;Sets temp to 0

M140 S0 ;Sets temp to 0

G92 E1 ;Extrudes fillament?

G1 E-1 F300 :Retract the filament

G91 G1 Z20 F600 ;drops Z so I can stop buying limit switches

T-1 ;Sets all tools to inactive

G1 Y0 X0 F4000 ;move the carriage out of the way

M84 ;Stop the idle hold on all axis and extruder