Purchased Parts
Purchased parts for Jubilee are broken down into multiple shopping lists * (Current) Jubilee V2.0.2 * V2 Frame Shopping List (~$1485) * V2 2x Direct Drive Extruder Shopping List (~$200 per tool) * (Community Contributed) Jubilee V2.0.2 UK/EU BOM by HaythamB * V2.0.2 Frame Shopping List last updated Apr 12, 2020 * (Deprecated) Jubilee V1 * V1 Frame Shopping List (~$1550) * V1 2x Direct-Drive Extruder Shopping List (~$200 per tool)
Warnings About Cutting Your Own Extrusions
The shopping list specifies that the 2020 extrusions be cut-to-length by the vendor Misumi. This choice is intentional because Misumi can cut parts better (typically within +/- 0.1mm) than most Jubilee builders can without specialized tools. Later sections of the instructions also assume that extrusions of the same length are actually the same length; otherwise the squaring techniques in the instructions will not work. Long-story short: don’t cut the extrusions yourself unless you have a highly repeatable cutting setup.
Jubilee Component Vendors
Some small-scale manufacturers and part vendors are either reselling Jubilee’s hard-to-make parts, consolidating parts into kits, or selling modified parts from the stock model. These vendors are:
- 713Maker
- magnetic bed plates
- non-magnetic bed plates
- SeeMeCNC
- V1 Back Panel
- V1 Ethernet Side Panel
- V1 120V Side Panel
- V2 Back Panel
- V2 Ethernet Side Panel
- V2 120V Side Panel
- magnetic bed plates
- non-magnetic bed plates
- Assembled Twist Locks
- pre-laser-cut Delrin components
- Double Jump Electric (Joshua Vasquez) * Assembled Twist Locks
- Luke’s Laboratory
- cut-to-length spring guide
- mechanical “vitamin kits” for just the toolchanger (V2)
- Assembled Twist Locks, and pre-laser-cut Delrin components for the toolchanger only.
- High Temp 3D
- Spring Guide cut to length
- Complete 2020 Misumi Extrusion Kits
- Mandala Rose Works Jubilee crossbar
- Jubilee twist lock
- M3 Heat-set inserts
- Mandala Rose Works * Jubilee crossbar
Alternates
Depending on region-specific constraints some parts may be harder to purchase. We welcome suggestions and will list them here.