Assembly Tools

Safety Equipment

Wear protective eyewear while working with hand tools, especially while soldering, cutting springs, and press-fitting components

The following tools/extra-materials are required for assembling Jubilee:

Calipers, cheap or fancy. Both work.
Budget Soldering Iron for installing heat-set inserts
Heat-Set Insert Installation Tip. This one will work for M3 and M4 inserts.
1.5mm hex key
2.0mm ball screw hex key
2.5mm hex key
3.0mm ball screw hex key
M3 Hex Nut Driver. Filastruder or Amazon
0.5 Ton Benchtop Arbor Press is ideal but a bench vise will suffice.
2x 4 inch Quick-Grip Clamps for squaring the frame. These are sold in 2-packs, so one pack will suffice.
1 pair of 25-50-75 Blocks or 123 Blocks for squaring the frame
1 pair conventional wire cutters
1 Wire Crimpers, specifically SN-58B
1 pair hard wire cutters for cutting spring guide and wire rope. Note that cutting these parts with conventional wire cutters will destroy the wire cutters.
blue medium-strength threadlock such as Vibra-Tite
A flat surface to assemble the frame. A kitchen granite countertop is ideal, but a table will work too.