Baby Bullet Extruder
Revision as of 23:25, 29 August 2021 by Poofjunior (talk | contribs) (Created page with "This is the new default extruder as of Sept 2021. (Yes, it is named after Caltrain.) == Software Configuration == Here are the general operating conditions: * 681 steps/mm...")
This is the new default extruder as of Sept 2021. (Yes, it is named after Caltrain.)
Software Configuration
Here are the general operating conditions:
- 681 steps/mm
- 450-500mA Peak Current
- 0.03 - 0.05sec Pressure Advance
- 0mm nominal X offset from carriage
- 36.62mm nomiminal Y offset from carriage