Blurolls Wiring Harness Errata
As purchased, the Blurolls Tool Wire Harness for Jubilee 2.2 has a few mistakes that must be corrected before the wiring harness matches the wiring diagram.
Rework Tools
- 1x pair of SN-2549 Wire Crimpers
- 1x pair of conventional wire cutters
- 1x pair of conventional wire strippers for 22-24 AWG wires
- 1x small flathead screwdriver
Extra Parts to Buy
- 4x PH6 Pins PN: SPH-001T-P0.5L
- buy 12-20 as these are rather tricky to crimp by hand without some practice
- 1x LDO Motor Housing PN: PHR-6
- 4x Molex Micro-fit 3.0 Connector Housing PN: 0436400201
- 8x Molex Micro-fit 3.0 Housing Crimp Pins PN: 0430310001
- buy 12-20 as these are rather tricky to crimp by hand without some practice
Fixes to Apply
For this last check, you may need to pop the pins out of the board-side motor connector with a flathead screwdriver. (The pins and motor housing can be reused.)
