Assembly Instructions

From Jubilee
Revision as of 15:15, 10 February 2021 by Kelliead (talk | contribs) (→‎Part Prep)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
Let the build begin! Image Credit: @Danal on Discord

Building a Jubilee tool changer platform can be broken down into the following high-level discrete stages:

  1. Building the frame and tool-changer mechanism
  2. Connecting the electronics
  3. Tuning the build for its target application
  4. Building and connecting the tools

The instructions for one Jubilee frame are broken down below.

For assembly instructions and wiring diagrams related to tools, see the page for that particular tool from the Tools page.

Questions about the assembly? Check out the FAQs, or reach out on Discord.

Hardware

For the mechanical assembly, all subassemblies are detailed with step-by-step visual instructions.

Pre-requisite Knowledge

Frame Assembly Instructions

The instructions must be completed sequentially from Section 1 to Section 3. Instructions in the same section don’t depend on each other, so they can be done at the same time with a friend.

Part Prep

Before assembling the frame:

1. Install the set screws in the inside corner brackets: Working with Inside Corner Brackets

2. Install the heat set inserts in the appropriate parts.

Section I

Some instructions relate to older versions of the design. They are:


Section 2

Additionally, video Links to the CoreXY assembly are provided below:

Section 3

Electronics

duet2_frame_wiring.png

Pre-Requisite Knowledge

Wiring Diagrams

All wires needed for the frame are called out in the corresponding wiring diagrams. Important Note: XY motors and ZZZ motors have different pinouts, which means their wires will have a different color coding. This color coding is respected in the diagram, but it is easy to mix up the included cables in real life. Do keep motors and the wires they came with together as a pair. Do not mix motor cables.

Duet 2 Wiring

Duet3 Wiring

This wiring configuration matches the existing config files for the corresponding control board.

Supported Control Boards

Currently, only the Duet2 in conjunction with the Duex5 Expansion board is fully supported. To get a sense of the firmware requirements needed for porting Jubilee to other control boards, see the page on Adding Control Boards.

First Power-Up

Tuning

Depending on your machine's target application, you may need to do some additional tuning.

Tuning Before Your First 3D Print

Tuning Before Multicolor Drawing

Tools

For assembly instructions and wiring diagrams related to tools, see the page for that particular tool from the Tools page.